Brodit ProClip and Holders - Dedicated UK Supplier

These are detailed fitting Instructions for the Brodit Mount for your TomTom GO 720 GPS. This is how you fit your Holder with Pass-Through Connector mount onto your proclip. Full Instructions also come with your mount.

Please read all of the instructions and look at the pictures before attaching the holder. Important Note: The charger unit is fused internally with 2 A automotive re-settable thermal fuse, but if an external fuse is to be installed then connect a 2 A fuse holder and fuse inline with the Red wire close to the power source. Route the cable from the holder into the vehicle dashboard and secure the charger unit in place with the adhesive tape provided. Ensure the charger unit is securely mounted behind the dashboard in a well ventilated area that does not get hot!

Route the power cable from the charger unit to the power supply source in the vehicle and connect as follows: 1. Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis. 2. Connect the Red wire to a 12/24 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle.

Installation of the holder: 1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. 2. Place the attaching plate on desired position. Screw the attaching plate into place with the enclosed screws. 3. Place the holder over the attaching plate so the tilt swivel fits. Screw the holder onto the attaching plate. All cables that fit the device can be attached to the holder. 4. The holder is in place.

3.

4.

Once you have chosen your holder, you can then choose the vehicle specific Brodit Proclip to mount your device on your dashboard

What's in the Package?

Holder with Pass-Through Connector
4 x Screws (to mount onto the proclip or other mounting platform)
Fitting Instructions
Active holder for fixed installation. With tilt swivel. 12/24 Volt. With TMC connectivity (MiniUSB plug).

This Holder with Pass-Through Connector (279024 ) fits :

TomTom GO 520 for All Countries

TomTom GO 520 T for All Countries

TomTom GO 530 for All Countries

TomTom GO 530 T for All Countries

TomTom GO 720 for All Countries

TomTom GO 720 T for All Countries

TomTom GO 730 for All Countries

TomTom GO 730 T for All Countries

TomTom GO 920 for All Countries

TomTom GO 920 T for All Countries

TomTom GO 930 for All Countries

TomTom GO 930 T for All Countries

TomTom GO 630 for All Countries

TomTom GO 630 T for All Countries

TomTom WORK GO 7000 for All Countries