Brodit ProClip and Holders - Dedicated UK Supplier

These are detailed fitting Instructions for the Brodit Mount for your Apple iPhone 6 Plus Mobile Phone. This is how you fit your Holder for Cable Attachment mount onto your proclip. Full Instructions also come with your mount.

Please read all of the instructions and look at the pictures before installing.
 
1. Place the connector of the cable in the hole in the lower part of the holder. Carefully press the connector downward and forward so it passes the locking and goes into the hole. Press until you hear/feel the connector snap into place in the holder.
 
2. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws.
 
3. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw firm at first, then loosen it a bit so the holder is firmly in place, but still can be adjusted.
 
4. The holder is in place.

3.

4.

Once you have chosen your holder, you can then choose the vehicle specific Brodit Proclip to mount your device on your dashboard

What's in the Package?

Holder for Cable Attachment
4 x Screws (to mount onto the proclip or other mounting platform)
Fitting Instructions
For use with Apple original Lightning to USB Cable. With tilt swivel. Padded

This Holder for Cable Attachment (514661 ) fits :

Apple iPhone 6 Plus for All Countries